Physical Measurements Lab

Accurate and precise
measurements with data analysis.

Characterize your piece to make the right decisions.

Our instrumentation guarantees a wide range of physical measurements to help our customer know and characterize their process. Traceable calibration certificates guarantee regulatory compliance and reliability. GB Soluzioni can also calculate the Repeatibility and Reproducibility of every measurement on a part or material, helping assessing the variability of the process without bias and noise.

Full integration with our validation department provides statistical analysis and interpretation of the data collected

Currently GB Soluzioni has decided to certify his laboratory ISO 17025:2017 to better serve the customer. Certification process will start in 2020.

Dimensional Measurement

  • Resolution down to 0,1 µm
  • Optical measurement in XYZ
  • Touch probe in XYZ
  • Automated process suitable for large amount of measurements

Torque and Force

  • Peel Test according to ISO 11607, EN 868-5, ASTM D1876, ASTM D3330, ASTM F88
  • Resolution down to 0,01N
  • Maximum load: 500N
  • Speed up to 500 mm/min
  • Force/Torque Diagram

Small-bore connectors testing ISO 80369

  • Dimensional testing
  • Fluid leakage testing by pressure decay
  • Sub-atmospheric pressure air leakage
  • Stress Cracking
  • Resistance to separation from axial load
  • Resistance to separation from unscrewing
  • Resistance to overriding
  • Automated assembly to reference connectors with programmable torque tester
  • ISO 80369-20 compliant
  • Test method validation

Mass and Weight

  • Resolution down to 0,001 g
  • Full scale up to 410 g

Accelerated Aging

  • Test according to ANSI/AAMI/ISO 11607-1 and ASTM F1980-07
  • Temperature up to 130°C
  • Validation of customer load

Flow and Leak

  • Resolution down to 1 Pa
  • Resolution down to 1 cm³/h
  • Full scale up to 6 bar
  • Full scale up to 50 cm³/min
  • Leak and Flow test Assessing
  • Verification and certification of pressure measurements
  • Pressure and flow graph-chart

Data Analysis

  • Statistical analysis
  • Calculation of capability indexes
  • Gauge capability
  • Minitab integration